Skip to main content
615 Concrete Floors, polished, stained and coated concrete floors in Nashville TN 615-431-3789

New Floors & Installation

Concrete slab preparation by diamond grinding or shot blasting that opens the surface and removes contaminants for a lasting finish

Coatings, stains and polishes only last as long as the preparation under them. We prepare slabs the way manufacturers require.

Call or text today615-431-3789

Request concrete floor service

Tell us what is going on. We will contact you to confirm the details and set up a time to look at the job.

Or call 615-431-3789

By sending this you agree that we may contact you about your project. See our Privacy Policy.

Prefer to type? Text your request to 615-431-3789

Concrete Slab Preparation

Surface preparation is the foundation of every finish. Laitance, curing compounds, sealers, oils and dirt must come off, and the slab needs the right texture for the product that follows. Shot blasting gives a fast, even profile on large areas, while diamond grinding gives the best control and flatness.

We prepare slabs across Middle Tennessee, in Nashville garages, basements and commercial floors. We test the slab, choose grinding or blasting, control dust, repair flaws and measure the surface profile so the next step bonds the way it should.

What you get

Done right, from the first call

01

Grinding or shot blasting

The method is chosen for the product and the slab.

02

Surface profile matched

Texture is set for epoxy, polyaspartic or sealer.

03

Dust-controlled work

Machines run with industrial vacuums.

04

Flaw repair

Cracks and pits are repaired before finishing.

The process

How your service comes together

  1. 1

    Test

    We check hardness, contamination and profile.

  2. 2

    Prepare

    Machines open and clean the surface.

  3. 3

    Verify

    We check the finished profile and clean up.

FAQ

Common questions about slab preparation

Is shot blasting better than grinding?

Each has strengths. Blasting is fast on large flat areas, while grinding gives more control and is better near edges.

Can I skip preparation to save time?

Skipping it is the most common reason coatings fail. We do not recommend it.

How do you know the profile is right?

We compare the surface to profile standards for the product being installed.

Let us help with your slab preparation

Call, text or send the form. Tell us about the floor and we will take it from there.

615-431-3789Text